- 1 Should a water pump pulley spin freely?
- 2 How do you know if your water pump pulley is bad?
- 3 Should a water pump pulley have play?
- 4 What does a water pump pulley do?
- 5 How do I stop my water pump pulley from turning?
- 6 Can I drive with a broken water pump?
- 7 What kind of noise does a bad water pump make?
- 8 What noise does a bad pulley make?
- 9 What does a broken water pump sound like?
- 10 How much does it cost to replace a water pump pulley?
- 11 Can a bad water pump pulley rattle?
- 12 How long does it take to put a water pump on?
- 13 How long will a water pump last after it starts leaking?
Should a water pump pulley spin freely?
New water pump should be nice a tight and not spin freely. Also the rotation should be perfectly smooth. If it feels gritty, it’s bad. Bearings, like the tensioner pulley are the same.
How do you know if your water pump pulley is bad?
Symptoms of a Bad or Failing Water Pump Pulley Physical damage to the water pump pulley. The most obvious sign that a problem exists with your water pump pulley is if it’s physically damaged. Extensive wear on the water pump or serpentine belt. Grinding sound from the front of your car. Engine overheats.
Should a water pump pulley have play?
The water pump pulley should not have much ” play ” in it at all. Any side to side movement would indicate wear in the shaft bushing and likely be a leak at some point in the near future. Idler pulley has a bearing in it that has a little play in it, but not much.
What does a water pump pulley do?
The water pump pulley on a car helps to provide the power that this part needs to push the coolant through the engine. Every time that your car is cranked, the water pump pulley will have to spin freely in order for the car’s cooling system to work properly.
How do I stop my water pump pulley from turning?
What I do is take a screwdriver or a pry bar and place it between the heads of two bolts so it prevents the water pump from turning. You are going to replace the belt, so damage will not be a concern. Put your wrench on the bolt and turn the pulley while you let the file get pulled in between the pulley and belt.
Can I drive with a broken water pump?
Water pumps don’t “break” and start leaking; they have things called “weep holes”, so that when the bearings are starting to wear down, it will slowly start to drip, that way you know its time to replace it. If that is all that is happening, you’re fine to drive it for a week or so.
What kind of noise does a bad water pump make?
Whining or Groaning Noise A whining or groaning noise usually means that either a drive belt is loose, or the water pump pulley is bad.
What noise does a bad pulley make?
Belt squealing If the surface of the idler pulley wears, or the pulley seizes or binds it may cause the engine belt to squeal as a result of it rubbing against the surface of the pulley. In some instances a bad pulley may bind or slip and cause the belt to squeal when the engine is first started.
What does a broken water pump sound like?
If you hear a high-pitched, whining sound that increases as you accelerate – it could indicate a faulty water pump. These sounds are caused by a loose belt and the belt becomes loose when the pulley is loose or the bearings are wearing out.
How much does it cost to replace a water pump pulley?
Below are some pulley labels and their respective product offers. Dorman: Water pump pulleys from Dorman are available as OE replacements. Their standard prices range from $33.98 up to $55.77, all with Dorman’s lifetime limited warranty.
Can a bad water pump pulley rattle?
Misalignment of the Pulley When a water pump bearings are going out it will allow the water pump pulley to wobble and make squeaking or grinding noises while in operation.
How long does it take to put a water pump on?
The range is approximately two to three hours depending on whether your vehicle has power steering and/or air conditioning. It is economical to replace the pump on a mobile basis and you can obtain a repair quote for mobile replacement by referring to YourMechanic’s water pump replacement service page.
How long will a water pump last after it starts leaking?
0-50 miles As long as the bearings don’t fail, then I would venture to say that the seal has failed and if it is “fresh” it will probably make 50 miles, just make sure that you don’t heat things up with extra load (extra pressure on cooling system)..